| [9] | 1 | /*
|
|---|
| 2 | * 3c503.h A shared memory driver for Etherlink II board.
|
|---|
| 3 | *
|
|---|
| 4 | * Created: Dec. 20, 1996 by G. Falzoni <falzoni@marina.scn.de>
|
|---|
| 5 | */
|
|---|
| 6 |
|
|---|
| 7 | #define EL2_MEMTEST 0 /* Set to 1 for on board memory test */
|
|---|
| 8 |
|
|---|
| 9 | #define EL2_GA 0x0400 /* Offset of registers in Gate Array */
|
|---|
| 10 |
|
|---|
| 11 | /* EtherLink II card */
|
|---|
| 12 |
|
|---|
| 13 | #define EL2_STARTPG (EL2_GA+0x00) /* Start page matching DP_PSTARTPG */
|
|---|
| 14 | #define EL2_STOPPG (EL2_GA+0x01) /* Stop page matching DP_PSTOPPG */
|
|---|
| 15 | #define EL2_DRQCNT (EL2_GA+0x02) /* DMA burst count */
|
|---|
| 16 | #define EL2_IOBASE (EL2_GA+0x03) /* I/O base jumpers (bit coded) */
|
|---|
| 17 | #define EL2_MEMBASE (EL2_GA+0x04) /* Memory base jumpers (bit coded) */
|
|---|
| 18 | #define EL2_CFGR (EL2_GA+0x05) /* Configuration Register for GA */
|
|---|
| 19 | #define EL2_CNTR (EL2_GA+0x06) /* Control(write) and status(read) */
|
|---|
| 20 | #define EL2_STATUS (EL2_GA+0x07)
|
|---|
| 21 | #define EL2_IDCFG (EL2_GA+0x08) /* Interrupt/DMA configuration reg */
|
|---|
| 22 | #define EL2_DMAAH (EL2_GA+0x09) /* DMA address register (High byte) */
|
|---|
| 23 | #define EL2_DMAAL (EL2_GA+0x0A) /* DMA address register (Low byte) */
|
|---|
| 24 | #define EL2_VP2 (EL2_GA+0x0B) /* Vector pointer - set to */
|
|---|
| 25 | #define EL2_VP1 (EL2_GA+0x0C) /* reset address (0xFFFF:0) */
|
|---|
| 26 | #define EL2_VP0 (EL2_GA+0x0D) /* */
|
|---|
| 27 | #define EL2_FIFOH (EL2_GA+0x0E) /* FIFO for progr. I/O (High byte) */
|
|---|
| 28 | #define EL2_FIFOL (EL2_GA+0x0F) /* FIFO for progr. I/O (Low byte) */
|
|---|
| 29 |
|
|---|
| 30 | #define EL2_EA0 0x00 /* Most significant byte of ethernet address */
|
|---|
| 31 | #define EL2_EA1 0x01
|
|---|
| 32 | #define EL2_EA2 0x02
|
|---|
| 33 | #define EL2_EA3 0x03
|
|---|
| 34 | #define EL2_EA4 0x04
|
|---|
| 35 | #define EL2_EA5 0x05 /* Least significant byte of ethernet address */
|
|---|
| 36 |
|
|---|
| 37 | /* Bits in EL2_CNTR register */
|
|---|
| 38 | #define ECNTR_RESET 0x01 /* Software Reset */
|
|---|
| 39 | #define ECNTR_THIN 0x02 /* Onboard transceiver enable */
|
|---|
| 40 | #define ECNTR_AUI 0x00 /* Onboard transceiver disable */
|
|---|
| 41 | #define ECNTR_SAPROM 0x04 /* Map the station address prom */
|
|---|
| 42 |
|
|---|
| 43 | /* Bits in EL2_CFGR register */
|
|---|
| 44 | #define ECFGR_NORM 0x49 /* Enable 8k shared memory, no DMA, TC int */
|
|---|
| 45 | #define ECFGR_IRQOFF 0xC9 /* As above, disable 8390 IRQ */
|
|---|
| 46 |
|
|---|
| 47 | /* Shared memory management parameters */
|
|---|
| 48 | #define EL2_SM_START_PG 0x20 /* First page of TX buffer */
|
|---|
| 49 | #define EL2_SM_STOP_PG 0x40 /* Last page +1 of RX ring */
|
|---|
| 50 |
|
|---|
| 51 | /* Physical addresses where an Etherlink board can be configured */
|
|---|
| 52 | #define EL2_BASE_0C8000 0x0C8000
|
|---|
| 53 | #define EL2_BASE_0CC000 0x0CC000
|
|---|
| 54 | #define EL2_BASE_0D8000 0x0D8000
|
|---|
| 55 | #define EL2_BASE_0DC000 0x0DC000
|
|---|
| 56 |
|
|---|
| 57 | #define inb_el2(dep,reg) (inb((dep)->de_base_port+(reg)))
|
|---|
| 58 | #define outb_el2(dep,reg,data) (outb((dep)->de_base_port+(reg),(data)))
|
|---|
| 59 |
|
|---|
| 60 | /** 3c503.h **/
|
|---|
| 61 |
|
|---|
| 62 | /*
|
|---|
| 63 | * $PchId: 3c503.h,v 1.3 2003/09/10 15:34:29 philip Exp $
|
|---|
| 64 | */
|
|---|
