source: trunk/minix/drivers/dpeth/3c509.h@ 10

Last change on this file since 10 was 9, checked in by Mattia Monga, 14 years ago

Minix 3.1.2a
File size: 6.1 KB
RevLine 
[9]1/*
2** File: 3c509.h Jun. 01, 2000
3**
4** Author: Giovanni Falzoni <gfalzoni@inwind.it>
5**
6** Interface description for 3Com Etherlink III board.
7**
8** $Log: 3c509.h,v $
9** Revision 1.1 2005/06/29 10:16:46 beng
10** Import of dpeth 3c501/3c509b/.. ethernet driver by
11** Giovanni Falzoni <fgalzoni@inwind.it>.
12**
13** Revision 2.0 2005/06/26 16:16:46 lsodgf0
14** Initial revision for Minix 3.0.6
15**
16** $Id: 3c509.h,v 1.1 2005/06/29 10:16:46 beng Exp $
17*/
18
19/* Command codes */
20#define CMD_GlobalReset 0x0000 /* resets adapter (power up status) */
21#define CMD_SelectWindow (1<<11) /* select register window */
22#define CMD_StartIntXcvr (2<<11) /* start internal transciver */
23#define CMD_RxDisable (3<<11) /* rx disable */
24#define CMD_RxEnable (4<<11) /* rx enable */
25#define CMD_RxReset (5<<11) /* rx reset */
26#define CMD_RxDiscard (8<<11) /* rx discard top packet */
27#define CMD_TxEnable (9<<11) /* tx enable */
28#define CMD_TxDisable (10<<11) /* tx disable */
29#define CMD_TxReset (11<<11) /* tx reset */
30#define CMD_Acknowledge (13<<11) /* acknowledge interrupt */
31#define CMD_SetIntMask (14<<11) /* set interrupt mask */
32#define CMD_SetStatusEnab (15<<11) /* set read zero mask */
33#define CMD_SetRxFilter (16<<11) /* set rx filter */
34#define CMD_SetTxAvailable (18<<11) /* set tx available threshold */
35#define CMD_StatsEnable (21<<11) /* statistics enable */
36#define CMD_StatsDisable (22<<11) /* statistics disable */
37#define CMD_StopIntXcvr (23<<11) /* start internal transciver */
38
39/* Status register bits (INT for interrupt sources, ST for the rest) */
40#define INT_Latch 0x0001 /* interrupt latch */
41#define INT_AdapterFail 0x0002 /* adapter failure */
42#define INT_TxComplete 0x0004 /* tx complete */
43#define INT_TxAvailable 0x0008 /* tx available */
44#define INT_RxComplete 0x0010 /* rx complete */
45#define INT_RxEarly 0x0020 /* rx early */
46#define INT_Requested 0x0040 /* interrupt requested */
47#define INT_UpdateStats 0x0080 /* update statistics */
48
49/* Rx Status register bits */
50#define RXS_Error 0x4000 /* error in packet */
51#define RXS_Length 0x07FF /* bytes in RxFIFO */
52#define RXS_ErrType 0x3800 /* Rx error type, bit 13-11 */
53#define RXS_Overrun 0x0000 /* overrun error */
54#define RXS_Oversize 0x0800 /* oversize packet error */
55#define RXS_Dribble 0x1000 /* dribble bit (not an error) */
56#define RXS_Runt 0x1800 /* runt packet error */
57#define RXS_Framing 0x2000 /* framing error */
58#define RXS_CRC 0x2800 /* CRC error */
59
60/* Tx Status register bits */
61
62/* Window Numbers */
63#define WNO_Setup 0x0000 /* setup/configuration */
64#define WNO_Operating 0x0001 /* operating set */
65#define WNO_StationAddress 0x0002 /* station address setup/read */
66#define WNO_Diagnostics 0x0004 /* diagnostics */
67#define WNO_Statistics 0x0006 /* statistics */
68
69/* Register offsets - Window 1 (WNO_Operating) */
70#define REG_CmdStatus 0x000E /* command/status */
71#define REG_TxFree 0x000C /* free transmit bytes */
72#define REG_TxStatus 0x000B /* transmit status (byte) */
73#define REG_RxStatus 0x0008 /* receive status */
74#define REG_RxFIFO 0x0000 /* RxFIFO read */
75#define REG_TxFIFO 0x0000 /* TxFIFO write */
76
77/* Register offsets - Window 0 (WNO_Setup) */
78#define REG_CfgControl 0x0004 /* configuration control */
79
80/* Register offsets - Window 2 (WNO_StationAddress) */
81#define REG_SA0_1 0x0000 /* station address bytes 0,1 */
82
83/* Register offsets - Window 3 (WNO_FIFO) */
84
85/* Register offsets - Window 4 (WNO_Diagnostics) */
86#define REG_MediaStatus 0x000A /* media type/status */
87
88/* Register offsets - Window 5 (WNO_Readable) */
89
90/* Register offsets - Window 6 (WNO_Statistics) */
91#define REG_TxBytes 0x000C /* tx bytes ok */
92#define REG_RxBytes 0x000A /* rx bytes ok */
93#define REG_TxDefer 0x0008 /* tx frames deferred (byte) */
94#define REG_RxFrames 0x0007 /* rx frames ok (byte) */
95#define REG_TxFrames 0x0006 /* tx frames ok (byte) */
96#define REG_RxDiscarded 0x0005 /* rx frames discarded (byte) */
97#define REG_TxLate 0x0004 /* tx frames late coll. (byte) */
98#define REG_TxSingleColl 0x0003 /* tx frames one coll. (byte) */
99#define REG_TxMultColl 0x0002 /* tx frames mult. coll. (byte) */
100#define REG_TxNoCD 0x0001 /* tx frames no CDheartbt (byte) */
101#define REG_TxCarrierLost 0x0000 /* tx frames carrier lost (byte) */
102
103/* Various command arguments */
104
105#define FilterIndividual 0x0001 /* individual address */
106#define FilterMulticast 0x0002 /* multicast/group addresses */
107#define FilterBroadcast 0x0004 /* broadcast address */
108#define FilterPromiscuous 0x0008 /* promiscuous mode */
109
110/* Resource Configuration Register bits */
111#define EL3_CONFIG_IRQ_MASK 0xF000
112
113/* Address Configuration Register bits */
114#define EL3_CONFIG_XCVR_MASK 0xC000
115#define EL3_CONFIG_IOBASE_MASK 0x001F
116
117#define TP_XCVR 0x0000
118#define BNC_XCVR 0xC000
119#define AUI_XCVR 0x4000
120
121#define EL3_IO_BASE_ADDR 0x200
122
123/* Transmit Preamble */
124
125/* Bits in various diagnostics registers */
126#define MediaLBeatEnable 0x0080 /* link beat enable (TP) */
127#define MediaJabberEnable 0x0040 /* jabber enable (TP) */
128
129/* Board identification codes, byte swapped in Rev 0 */
130#define EL3_3COM_CODE 0x6D50 /* EISA manufacturer code */
131#define EL3_PRODUCT_ID 0x9050 /* Product ID for ISA board */
132
133/* EEProm access */
134#define EE_3COM_NODE_ADDR 0x00
135#define EE_PROD_ID 0x03
136#define EE_MANUFACTURING_DATA 0x04
137#define EE_3COM_CODE 0x07
138#define EE_ADDR_CFG 0x08
139#define EE_RESOURCE_CFG 0x09
140#define EE_SW_CONFIG_INFO 0x0D
141#define EE_PROD_ID_MASK 0xF0FF /* Mask off revision nibble */
142
143/* Contention logic */
144#define EL3_READ_EEPROM 0x80
145#define EL3_ID_GLOBAL_RESET 0xC0
146#define EL3_SET_TAG_REGISTER 0xD0
147#define EL3_ACTIVATE_AND_SET_IO 0xE0
148#define EL3_ACTIVATE 0xFF
149
150/* Software Configuration Register bits */
151
152/* Configuration Control Register bits */
153#define EL3_EnableAdapter 0x01
154
155/* EL3 access macros */
156#define inb_el3(dep,reg) (inb((dep)->de_base_port+(reg)))
157#define inw_el3(dep,reg) (inw((dep)->de_base_port+(reg)))
158#define outb_el3(dep,reg,data) (outb((dep)->de_base_port+(reg),(data)))
159#define outw_el3(dep,reg,data) (outw((dep)->de_base_port+(reg),(data)))
160
161#define SetWindow(win) \
162 outw(dep->de_base_port+REG_CmdStatus,CMD_SelectWindow|(win))
163
164/** 3c509.h **/
Note: See TracBrowser for help on using the repository browser.